-
Turn all switches to OFF position on both the extractor and Mytee Hot Turbo™.
-
Fill extractor with preferred solution.
-
Connect male quick disconnect of Mytee Hot Turbo™ to the female quick disconnect of the extractor.
-
Connect male quick disconnect of the solution hose assembly to the female quick disconnect of the Mytee Hot Turbo™.
-
Turn pump to ON position.
-
Engage trigger to dispense solution throughout extractor and Mytee Hot Turbo™ until the water flow is sufficient.
-
Turn Mytee Hot Turbo™ switches to the on position (please keep in mind that each switch pulls approximately 2.5 amps).
-
Please allow for a 5-10 minute Preheat cycle to obtain maximum heat
-
In the event of dramatic heat loss allow Mytee Hot Turbo™ to Reheat for 1-3 minutes.
-
Temperatures may vary depending on pump (pressure and volume) and jet size.
